ZEnworks 10 installing hangs Configuring ZENworks Database

Today I was preparing the N3098. The first exercise is installing ZCM10 SP1.
To my suprise the install hangs while configuring the ZENworks database. After some examination I discovered that the virtual machine (The machine runs in VMware Workstation) did not have a ip bound to eth0.

This was due the fact that the mac-adres changed for the virtual NIC. So SLES could not configure the ‘new’ NIC. After removing the old eth0 nic from
/etc/udev/rules.d/30-net_persistent_names.rules and renamed the section for eth1 to eth0 the installation went fine.

About Michael
Michael Wilmsen is a VMware training/consultant (no specific order) with more than 15 years in the IT industry. Main focus is VMware vSphere, Horizon View and Site Recovery Manager with a deepdive to performance. Michael is VCDX 210, VCAP 4/5 certified, has been rewarded with the vExpert title from 2011, is a PernixPro, Nutanix Tech Champion and a Nutanix Platform Professional.

RSS feed for comments on this post. TrackBack URI

Leave a Reply

You must be logged in to post a comment.